在全自动砂浆水泥挍拌车的正常运行过程中，如果气路系统经常出现问题，其运行功率会线性下降，甚无法正常启动的现象也很严重。

In the normal operation process of the automatic mortar cement mixer, if the air system often has problems, its operation power will decline linearly, and even can not start normally.

1.全自动砂浆水泥挍拌车的空压机应水平放置，固定并通风。

1. The air compressor of automatic mortar cement mixer should be placed horizontally, fixed and ventilated.

2.无法承受风吹雨打，也不能暴露在阳光下。

2. Can't bear the wind and rain, and can't be exposed to the sun.

3.调整气压自动开关的上限和下限。如果压力太低，则气缸会减速，如果压力太高，则气动系统的密封件会很不幸。

3. Adjust the upper and lower limits of the air pressure automatic switch. If the pressure is too low, the cylinder will slow down. If the pressure is too high, the seals of the pneumatic system will be very unfortunate.

4.检查全自动砂浆水泥挍拌车的润滑油油位，并坚持使油位在量油尺的上，下线之间。当油位接近下线时，添加新油。

4. Check the lubricating oil level of the automatic mortar cement mixing truck, and keep the oil level between the upper and lower lines of the dipstick. When the oil level is near the end of the line, add new oil.

5.检查传送带的张力是否合适。用手指按压皮带时，皮带应下垂约10mm。更换传送带时，应更换整个组以保持共同的张力。

5. Check whether the tension of the conveyor belt is appropriate. When pressing the belt with fingers, the belt should sag about 10 mm. When replacing the conveyor belt, the whole group should be replaced to maintain the common tension.

6.气体系统必须充满令人满意的机油，并坚持令人满意的机油量和令人满意的正常运行。只有这样，前混合器的功率才能一起使用，以延长气体系统的使用寿命。

6. The gas system must be filled with satisfactory oil, and adhere to satisfactory oil quantity and satisfactory normal operation. Only in this way can the power of the front mixer be used together to extend the service life of the gas system.

今日 自动上料混凝土搅拌车的精彩内容就给大家分享到这了，更多的精彩内容请点击我们的网站 //www.scritchies.com留言，或者直接拨打电话询问，我们会有专门的人员为您服务.

Today's auto feeding concrete mixer's wonderful content will be shared with you. For more wonderful content, please click our website //www.scritchies.com Leave a message, or call directly, we will have special staff to serve you