In the actual operation of the equipment, the transmission of automatic feeding mixer is also a very important part. Therefore, in the process of use, it is necessary to check the oil quality to a certain extent. How to operate?
1.将小型混凝土搅拌运输车停在水平地面上,并拧紧手刹。
1. Park the small concrete mixer truck on the horizontal ground and tighten the hand brake.
2.让发动机怠速运转几分钟。
2. Let the engine idle for a few minutes.
3.踩下制动踏板,将操纵杆移倒档,前进档等,并在每个档中停留几秒钟,以向液压变矩器和所有换档执行器注满液压油。将操纵杆移停车位置。
3. Press the brake pedal, move the control lever to reverse, forward, etc., and stay in each gear for a few seconds to fill the hydraulic torque converter and all shift actuators with hydraulic oil. Move the lever to the park position.
4.从加油管中拉出自动变速箱油尺,将所有清洁过的油尺插入加油管,然后拉出,并检查油尺上的油位。
4. Pull out the automatic transmission oil dipstick from the oil filler pipe, insert all cleaned oil dipsticks into the oil filler pipe, then pull out, and check the oil level on the oil dipstick.
在检查自动供料混合器的传动装置或对传动装置进行故障排除之前,请先检查传动装置的油位和质量。将换档器置于P档,并使发动机怠速运转少几分钟,机油达到正常工作温度,并且汽车需要停在水平道路上,以确保差速器和变速箱油之间的油位高。传输正常,稳定。
Before checking or troubleshooting the transmission of the automatic feeding mixer, please check the oil level and quality of the transmission. Place the shifter in P gear and allow the engine to idle for at least a few minutes, the oil reaches the normal operating temperature, and the car needs to stop on a level road to ensure a high oil level between the differential and the transmission oil. Transmission is normal and stable.
在炎热的夏天,混凝土自动装料搅拌机的内部噪音和温度会增加。夏季温度不高,但这可能是由于发动机或汽车中机油的温度所致。
In hot summer, the internal noise and temperature of the automatic concrete loading mixer will increase. The temperature is not high in summer, but this may be due to the temperature of oil in the engine or car.
1.洗车水箱中的水量不足以清理干净。向洗车水箱注满水。
1. The amount of water in the car washing water tank is not enough to clean up. Fill the car wash water tank with water.
2.如果吸管的进气口堵塞或堵塞,可以检查并拧紧吸管。不要呼吸空气。
2. If the air inlet of the straw is blocked or blocked, check and tighten the straw. Don't breathe air.
3.油箱液位过低,并且油液中的空气被吸入泵中。如果发生这种情况,您可以添加带有相同标签的液压油。
3. The liquid level in the oil tank is too low, and the air in the oil is sucked into the pump. If this happens, you can add hydraulic oil with the same label.
4.如果泵的安装支架不够牢固,则在工作期间会产生振动和噪音。在这种情况下,可以加固油泵支架。
4. If the mounting bracket of the pump is not firm enough, vibration and noise will be generated during operation. In this case, the oil pump support can be reinforced.
5.堵塞的滤芯会使吸油困难或不充分。在这种情况下,请清洁滤芯或更换滤芯。
5. Blocked filter element will make oil absorption difficult or insufficient. In this case, clean the filter element or replace the filter element.
6.油冷却风扇未打开。卸下:打开冷却风扇。
6. The oil cooling fan is not turned on. Remove: turn on the cooling fan.
7.如果液压油不符合要求或油太粘,请更换符合标签要求的低粘度液压油。
7. If the hydraulic oil does not meet the requirements or the oil is too viscous, please replace the low viscosity hydraulic oil that meets the label requirements.
8.储罐中有坚硬的混凝土。如果发生这种情况,请及时清理并铲起。
8. There is hard concrete in the tank. If this happens, please clean and shovel it in time.
9.输入万向节轴之间的连接角度以及万向节轴与取力器之间的连接角度太大,如果松开会产生噪音,在这种情况下,请在时间内检查并拧紧。
9. The connection angle between the input universal joint shaft and the connection angle between the universal joint shaft and the power take-off is too large. If it is loosened, it will produce noise. In this case, please check and tighten it within a time.
以上就是为大家介绍的有关
江南app平台官网 车的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务
//www.scritchies.com/
The above is a detailed introduction about the cost of self loading concrete mixing tank truck. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service //www.scritchies.com/