Method for cleaning soil slag by concrete mixer:

混凝土搅拌车这种机械设备在长时间的使用中不免会存在故障的发生，这时就需要我们对机械土渣进行清理工作。那么接下来让我们详细了解一下关于设备正确清理土渣的方法吧。

The mechanical equipment such as concrete mixer will inevitably have faults in long-term use. At this time, we need to clean up the mechanical soil residue. Then let's learn more about the method of correctly cleaning soil residue by equipment.

1、准备好紧急驱动软管，将小型混凝土搅拌车熄火，卸下液压马达上的高压油管接头。

1. Prepare the emergency drive hose, shut down the small concrete mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.

2、将救援车熄火，将其液压马达的高压油管卸下，并与故障车上的对应接头用紧急驱动软管相连。

2. Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor and connect it with the corresponding connector on the faulty vehicle with emergency drive hose.

3、发动救援车，将其操纵手柄拨出料位置，故障车内的混凝土即被排出。

3. Start the rescue vehicle and turn its control handle to the discharge position, and the concrete in the faulty vehicle will be discharged.

4、紧急驱动完毕后，将驱动软管卸下，并恢复两车原状。

4. After the emergency drive, remove the drive hose and restore the two vehicles to their original state.

5、在托轮和滚道之间放入木楔，以控制搅拌筒的旋转，一定要注意周围不要发生危险；将发动机熄火，拆松液压马达的一根高压油管，搅拌筒可自由旋转。

5. Put a wooden wedge between the supporting wheel and the raceway to control the rotation of the mixing drum. Be sure to pay attention to avoid danger around; Turn off the engine, loosen a high-pressure oil pipe of the hydraulic motor, and the mixing drum can rotate freely.

6、控制搅拌筒的旋转，使维修孔转到下部，然后打开维修孔，清理出筒内混凝土。混凝土排出完毕后，恢复小型混凝土搅拌车原状。

6. Control the rotation of the mixing drum to turn the maintenance hole to the lower part, and then open the maintenance hole to clean out the concrete in the drum. After the concrete is discharged, restore the small concrete mixer to its original state.

在正常情况下，合理的清理混凝土搅拌车使用中所出现的土渣，能够很好的保证设备在使用中的良好操作性能。同时在实际施工操作中，还需要我们对设备的运行多加关注才行，也能够很好的避免一些不必要的故障发生。

Under normal circumstances, reasonably cleaning the soil slag in the use of concrete mixer can well ensure the good operation performance of the equipment in use. At the same time, in the actual construction operation, we also need to pay more attention to the operation of the equipment, which can also well avoid some unnecessary faults.