① After driving 1000-1500km, the connecting bolts of the transmission shaft shall be tightened again, and the universal joint shall be lubricated with general lithium grease by hand pressure grease gun, which shall be lubricated regularly later.

　　② 传动轴在拆卸后再装配时，必须按传动轴上的装配方向标记进行，否则会严重影响传动轴的正常使用。

　　② When the transmission shaft is reassembled after disassembly, it must be marked according to the assembly direction on the transmission shaft, otherwise it will seriously affect the normal use of the transmission shaft.

　　③ 如需更换传动轴的零部件，更换后必须重新进行动平衡试验。

　　③ If the parts of the transmission shaft need to be replaced, the dynamic balance test must be carried out again after replacement.

　　④ 使用中如出现传动轴不平衡现象，应立即停车检查和修复，以免因其强烈震动而影响整个传动系的工作，甚造成严重事故。传动轴市区平衡主要是轴管弯曲、滚针轴承磨损或滑动花键装配不正确等原因造成的。

　　④ In case of unbalanced transmission shaft in use, stop the machine immediately for inspection and repair, so as not to affect the operation of the whole transmission system or even cause serious accidents due to its strong vibration. The urban balance of transmission shaft is mainly caused by the bending of shaft tube, the wear of needle bearing or the incorrect assembly of sliding spline.

　　⑤ 在整车大修时，应注意检查万向节在轴承中的松动量及滑动花键的磨损情况。当发现十字轴承的径向和轴间间隙过大、十字轴轴颈上有明显沟痕或花键齿磨损严重时，应更换相应总成，必要时更换传动轴总成。

　　⑤ During the overhaul of the whole vehicle, pay attention to check the looseness of the universal joint in the bearing and the wear of the sliding spline. When it is found that the radial and inter shaft clearance of the cross bearing is too large, there are obvious grooves on the cross shaft journal or the spline teeth are seriously worn, the corresponding assembly shall be replaced, and the transmission shaft assembly shall be replaced if necessary.

　　以上内容由 搅拌车厂家整理发布，更多的相关信息可以点击官网进行咨询： //www.scritchies.com/

　　The above content is organized and released by the mixer manufacturer of China Science and Technology Corporation. For more information, please click the official website for consultation: http://www.jufengjiabangji.com/